AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Structurix nova processor gears3/12/2023 Detailed spectral information from three target locations is provided simultaneously: the incident x-ray source, the scattered signal from unshocked foam, and the scattered signal from shocked foam. The data is composed of three spatially distinct spectra that were simultaneously captured with a single spectrometer with high spectral (4.8 eV) and spatial (190 µm) resolutions. Both unshocked and shocked portions of the foam target were probed with 6.2 keV x-rays produced by focusing the Z-Beamlet laser onto a nearby Mn foil. The impact of the flyer plate on a CH2 foam target produced a shocked state with an estimated pressure of 0.75 Mbar, density of 0.52 g/cm3, and temperature of 4.3 eV. The large (> 20 MA) electrical current produced by Z was used to launch Al flyer plates up to 25 km/s. For the first time, space-resolved x-ray Thomson scattering (XRTS) spectra from shocked carbon foams were recorded on Z. The measurements were taken using selected anodes, filters, and applied voltages to produce well-defined energy lines.Įxperiments on the Sandia Z pulsed-power accelerator have demonstrated the ability to produce warm dense matter (WDM) states with unprecedented uniformity, duration, and size, which are ideal for investigations of fundamental WDM properties. A broader range of energies was selected to compare results with previously published data. The absolute response of Agfa D4 x-ray film from 705 to 4620 eV has been measured using the Nevada National Security Site Manson x-ray source. These calibration efforts are vital to the accuracy of the NIF opacity measurements and are conducted in a previously un-studied x-ray energy range under a new film development protocol required by NIF. The calibration of Agfa D4 x-ray film for use in the OpSpec is communicated here. However, Agfa D4 and D3sc x-ray films’ higher spatial resolution provides increased spectral resolution to the data over the IP-TR image plates, driving the desire for regular use of x-ray film as a detecting medium. The soft x-ray Opacity Spectrometer (OpSpec) fielded at the NIF has an elliptically shaped crystal design that measures x rays in the 900–2100 eV range and currently uses an image plate as the detecting medium. Our items do not come with manuals or any other accessories unless shown and/or stated that they are included.X-ray films remain a key asset for high-resolution x-ray spectral imaging in high-energy-density experiments conducted at the National Ignition Facility (NIF). If one is pictured it is for testing purposes only unless it is attached or stated that it will be included.ĥ. ![]() We do not have power cords to provide unless they are attached to the item or unless stated that they are provided. We have no knowledge of the history of the equipment.Ĥ. NO REFUNDS OR RETURNS are given for parts/repair items or freight items. Please reach out to us directly if there is a problem. We are surplus equipment dealers and do not have the ability or knowledge to test equipment for functionality beyond plugging it in and describing what we observe as best we can.Ģ You are purchasing used equipment – most is untested as stated in our description. ![]() do you have a dock or forklift for delivery or need a tailgate deliveryġ. For us to check rates, we need the following info: 1. We can arrange shipping or you can arrange your own. ![]() $25 CHARGE FOR PALLETIZING/PREP FOR SHIPMENT. ITEM IS TOO LARGE FOR COMMON CARRIERS, SO MUST BE SHIPPED VIA FREIGHT. Due to the size and weight of freight shipping, sold as is. High cost, high value equipment for a fraction of the new /replacement price. Dirty and worn! No means to test further. Has some cosmetic wear/some cracks in the casing. COMES AS SHOWN! Acquired from a reliable source.
0 Comments
Read More
Leave a Reply. |